Politecnico di Torino  
Anno Accademico 2017/18  
01RXOQW Electronics Fundamentals and Applications 

Corso di Laurea Magistrale in Mechatronic Engineering (Ingegneria Meccatronica)  Torino 





Esclusioni: 01PCZ 
Presentazione
This course is taught in English.
The aim of the module is to teach to analyse and design basic electrical and electronic circuits that are the base of complex embedded analog and digital systems used in mechatronics applications. The module will start from basic building blocks in the DC and AC domains together with the necessary analysis and simulation techniques. A complete section of the module will be used to analyze available technologies and components. The last section is devoted to digital basic building blocks. 
Risultati di apprendimento attesi
Become familiar with passive circuits in DC and AC domain.
Become familiar with analog and digital electronics. Design small analog systems from specifications. Design a digital circuit and the interface between it and a load. Become familiar with the experimental lab, instruments and measurement techniques for analog and digital circuits. 
Prerequisiti / Conoscenze pregresse
Physics: power and energy, basic electromagnetics.
Mathematics: algebra of complex numbers, linear algebra and matrix analysis, algebraic linear systems, firstorder linear differential equations, basis of Laplace transform. 
Programma
Part I DC Circuits (2 CFU)
• Quantities and Units • Voltage, Current, and Resistance • Ohm’s Law, Energy and Power • Series Circuits • Parallel Circuits • SeriesParallel Circuits Part II AC Circuits (2CFU) • Introduction to Alternating Current and Voltage • Capacitors, Inductors • Laplace transform, Bode diagrams • RC and RLC Circuits and Resonance • Time Response of Reactive Circuits • Transformers Part III Devices (2,5 CFU) • Semiconductors • Diodes and Applications • Transistors (BJT, JFET, MOS) and Applications • The Operational Amplifier • Basic OpAmp Circuits • I order active filters Part IV Digital Electronics (1,5 CFU) • bipolar and MOS transistors in switching mode, switches, CMOS gates • Static and dynamic parameters, open drain and tristate output • ANDORNOT gates • basic sequential circuits (latches, flipflops, counters) 
Organizzazione dell'insegnamento
The course includes 8/9 experimental laboratory exercises (4 CFU) to be performed at the LED. The labs are organized in groups of three or four students. For each lab, groups must prepare reports that are evaluated and constitute part of the final examination mark.

Testi richiesti o raccomandati: letture, dispense, altro materiale didattico
For further details and discussions the recommended text is:
Neil Storey, Electronics: A Systems Approach (6th edition), Pearson Education UK, ISBN: 9781292114064 (print), 9781292114118 (PDF), 9781292133416 (ePub) 
Criteri, regole e procedure per l'esame
The final exam consists of two distinct written parts that are carried out together in the same day: one part related with exercises / project analysis (such as those seen during the course and in the laboratory exercises) and a second part related with theory (three or four open questions, 5 minutes time for each question).
The first part has a typical duration of about 60 minutes, while the second depends on the number of questions. The exam lasts less than two hours. During the first part (exercises), you can use notes, forms, educational materials, etc... but is NOT allowed the use of personal computers (only classic calculators). During the second part (theory), you can refer to anything and you do not need calculators. The two parts are evaluated separately and averaged between them: to be considered valid, both scores must be at least greater than 14 /30. The score obtained is added with the evaluation of laboratory exercises (delta max. between 2 and +4). The resulting score can be registered or further integrated (positive or negative) with an optional oral session. 
Orario delle lezioni 
Statistiche superamento esami 
